Acer Predator Connect W6 User Manual page 18

VII. Mesh supports WPS Onboarding, but in cases where connection is
hindered due to environmental interference, it's recommended to move the
agent closer to the controller, or restore the device to its factory default
settings and follow the Quick Setup process to reconfigure the agent.
Alternatively, you can perform the setup steps via Ethernet connection.
VIII. If the Mesh Wi-Fi SSID or password is changed in an existing Mesh
network, agents will apply the new configuration after the synchronization
process is done. If the agent does not apply the new configuration
successfully or the agent is in the offline status, it must go through the
onboarding process with the controller again. This is necessary for the
updated SSID or password to be applied to these agents.
In bridge mode, plug one end of the
RJ-45 cable into your host router and
the other end into Predator Connect
W6's WAN port.
Please note that after switching to
bridge mode, disable the DHCP
server. Some functions like Home
network priority, Hybrid QoS, Guest
Wi-Fi, Smart Home Wi-Fi, IPv6, DMZ,
Firewall, NAT, pass-through, port
forwarding, VPN, WAN ping, WAN
setting etc. may not work.
To access Predator Connect W6's
web portal in a bridge mode, it is
recommended using a static IP.
18 18