Kenwood TS-790A Instruction Manual page 28

4-2-4, AUTO mode
The AUTO mode function automatically sets the mode
to correspond to the selected frequency as shown be-
low, which is especially convenient for operations.
Note:
AUTO mode selection will not function when using
RIT.
1. 144 MHz Band
{With the TS-790A)
144.0 144.1 144.5 145.8 146.0 148.0
[cw USB FM LSB} FM
(With the TS-790E)
144.00 144.15 144.50, 145.80 146.00
| Cw | USB FM LSB
2. 430 MHz Band
(With the TS-790A)
430.0 435.0 438.0 450.0
FM USB FM
(With the TS-790E)
430.0 432.168 432.5 435.0 438.0 440.0
i cw | use] FM USB FM
3. 1200 MHz Band (Option)
(With the TS-790A}
1240 1260 1270 1300
FM LSB FM |
(With the TS-790E)
1240 1260 1270 1296 1296.15 1297 1300
FM LSB FM cw | USB FM
4-2-5. Power on function selection
The functions of this transceiver can be changed at
the time the transceiver is turned ON. Repeat when
releasing each function.
Key
CWI/N
| These functions include
: Audible mode announcement:
| Beep tones/Morse code
28
4-2-6. Frequency Step
1. The frequency step is set automatically depending
on the mode that has been selected.
(With the TS-790A)
(With the TS-7930E)
Mode | |
ssBicWw FM
| CH.OQ\STEP \
orp OFF 20 Hz 100 Hz
1OOHz 100 Hz
a up 2m band: 12.5 kHz
| OFF ES KAZ | Other band: 25 kHz
| N | 1 kHz | 5 kHz
2. When the TUNING knob is rotated at about 3 revo-
lutions a second a geometric increase in the tun-
ing step occurs that corresponds to the speed of
dial rotation. (When CH.Q switch is OFF.}