Table of Contents
Advertisement
Model 5344S
Operation and Programming
17.
Now rotate the RPG knob counter-clockwise. The marker will reappear on the trace. Move the
marker towards the Start frequency. Again when the marker is too close to the Start frequency, or it
violates the minimum separation restrictions described in paragraph 3-46, the marker will
disappear. However, when the marker is too close to the Start frequency, no error is displayed.
18.
Move marker 1 up to 2.01 GHz.
19.
As described in steps 13 and 15, select Marker 2 and place it at 2.030 GHz.
You should now see two dots on the sweep trace.
20.
Again using the RPG knob, move Marker 2 down towards Marker 1. Notice that when Marker 2
becomes too close to Marker 1, Marker 2 disappears. Whenever any two markers conflict, the
higher frequency conflicting marker is ignored. The marker wili always return once the spacing
conflict is resolved.
21.
Select Marker 3 and place it at 2.02 GHz.
22.
Two more markers could be selected provided there is no conflict.
Figure
3-76.
Markers (Continued)
Advertisement
Table of Contents
