Setting Up The User Data Port; Registering The Number Of Cameras 2-13 (En); Registering The Number Of Cameras Connected To The Video Transmitter - Sony RSE-500 Operating Instructions Manual

1 Select 26. RS-232C 2 from the SETTING menu.
Setting Up the USER DATA Port
The following screen appears.
INTERFACE: RS-232C
Y S-S100
MASTER
<CANCEL> «OK»
2 Select the interface using # or ¥, then press
3
4
"O go
ENTER.
If you are using the YS-S100 Camera Switcher
(not supplied), select YS-S100 MASTER.
The following screen appears.
INTERFACE: YS-S100
MASTER
BAUD RATE: 1200
2400
4800
9600
19200
38400
<CANCEL> «OK»
Select the baud rate using # or ¥, then press
ENTER.
Select the character bit using € or ®, then press
ENTER.
Select the parity bit using # or ¥, then press
ENTER.
Select the stop bit using € or œ, then press
ENTER.
The setting is registered and the SETTING menu
appears.
Number of Cameras :
Y ou need to register the number of cameras (up to
256) connected to the Video Transmitter to monitor all
of the camera pictures. You cannot switch to all of the
pictures if you don't register the number of cameras.
Registering the Number of |
Cameras Connected to the Video
Transmitter
1 select 8. CAMERA from the SETTING menu.
The following screen appears.
—— CAMERA
NO: ((T* X)
H 0123455788 BS
<CANCEL> <0K>
2 Select the number of cameras connected to the
Video Transmitter using € or ®, then press
ENTER.
The selected number is entered in the box.
* An asterisk is displayed where nothing is entered.
3 Move the cursor to «OK» using ¥, then press
ENTER.
The setting is registered and the SETTING menu
appears.
DUI
z Jeideyo
KCEAECECCA EGIT