Table of Contents
Advertisement
Installation Process_Charger
1
Use the enclosed fixing anchors and screws to hang the wall mount on the wall.
- Check the wall material and thickness of the finishing materials.
- The enclosed anchors and screws can be used when the wall material is non-cracking concrete, lightweight
concrete, strong natural stone, soft natural stone, brick, and hollow block.
- Never install on walls made of plasterboard or material made by compressing paper/wood dust (MDF). If you must
install, anchor screws must be fixed into the retaining wall (concrete) within the finishing materials. If there is no
retaining wall, an additional hanger must be installed before fixing the anchor screws.
- If installing on other unspecified wall materials, ensure the material can withstand a pull-out load of 70 kgf
(686 N) and a shearing load of 100 kgf (980 N) per anchor point.
a
d
- Use a 8 mm drill bit for concrete and a hammer (impact) drill.
a. Use a drill bit of 8 mm to drill holes to a depth of 80 mm - 100 mm (3.1 - 3.9 inches) at the anchor positions.
b. Clean the drilled holes.
c. Insert the enclosed anchor into the hole (use a hammer when inserting the anchor).
d. Press the wall mount against the wall in alignment with the hole positions. Ensure the angle adjustment part faces
upward.
e. Align the wall mount fixing screws with the holes and fasten them. At this point, tighten the screws to a torque of
45 kgf/cm - 60 kgf/cm (441 - 588 N) or more.
b
Wall-mounted Device Fixing Screw
e
Fixing Screw
Fixing Screw
Anchor
c
13
Advertisement
Table of Contents
