Setting Up The Analyzer From The Disk - HP 10314D User Manual

Setting Up the
Analyzer from
the Disk
Setting Up the HP 103140
1-12
The logic analyzer can be configured for 80386DX analysis by loading
the appropriate configuration file. Loading this file will also load the
inverse assembler file. The configuration file depends on which logic
analyzer you use and which coprocessor your target system is using.
Three configuration files can be used with 80386DX systems that use
any coprocessor. The other three configuration files should only be
used in systems that have an 80287 or 80387 math coprocessor.
To load the configuration file and inverse assembler:
1. Install
the flexiole disk in the front disk drive of the logic analyzer.
2. Select one of the following
men~:
• For the· HP 1650 series logic analyzers, select the 1/0 Disk
Operations menu;
• For the HP 16500 series logic analyzers, select the System
Front Disk menu.
3. Configure the menu to "Load" the analyzer with the appropriate
configuration file (see table 1-2, page 1-10).
4. For HP 16500 series logic analyzers, select the configuration file
with the knob, then touch "All" and select the correct module.
5. Execute the load operation to load the file into the logic analyzer.
HP 103140
80386DX Preprocessor Interface