3.3.6 Wiring of the contact output terminals
The following wiring example assumes that when the protective circuit is
activated, the magnetic contactor (MC) on the power supply side is opened to
switch off the main circuit power.
3.3.7 Wiring of the instrument connection terminals
The calibration resistor is not needed when the parameter unit is
used to make calibration.
MEMO
NFB
Power supply
Operation-ready
Stop
MC
Drive unit
FM
SD
Get other manuals https://www.bkmanuals.com
Drive unit
MC
R
S
T
F
B
MC
C
Meter
Calibration resistor
Refer to: Pr. 900 [Section 8.7.5]
3-12
3. WIRING