Operating The Device; Note On The Operation; Charging The Device; Using Sd Card - Siemens SIMATIC IPC MD-34A Operating Instructions Manual

Operating the device

5.1

Note on the operation

5.1.1

Charging the device

The battery charges as soon as the device is connected to the power supply.
Adhere to the Notes on power supply (Page 37).
Connect the device to the power supply as soon as the "Battery" LED displays a battery
capacity that is too low. You can find additional information in section: "Status displays
(Page 14)".
Power supply only with the original power supply unit
Only use the supplied original power supply unit for the power supply of the device. This
applies to both the connection to the device and to the connection to the docking station.
It is used to supply power to the device in mains operation with 120 V and 230 V power
supply networks.
The setting of the voltage range takes place automatically.
The following methods are available for charging the device:
Charging the device in the docking station
• Connect the external power supply to the docking station.
• Place the device correctly in the docking station.
Charging the device with external power supply unit
• Connect the external power supply unit to the device.
• Operate the device during the charging operation only on a table and not in mobile mode.
5.1.2

Using SD card

You can use the following cards:
• microSD cards
MD-34A
Operating Instructions, 08/2023, A5E52427535-AA
WARNING
5
47