Protective Cover For Oil; Installation Procedure - Mitsubishi Electric GT11 User Manual

One corner of the cover is pulled outside, and it hangs it
4
on the corner of the front panel of GOT.
The oil cover was hung and the edge of the oil cover is
5
sequentially obtained and obtain the oil cover to cover
rubber packing parts in the back of GOT of the front
panel.
(It is the order of the arrow from A side to D side.)
Please confirm all surroundings.
Check whether the rubber packing is fitted correctly into
the groove on the under side of the GOT front panel,
and then whether the protective cover for oil securely
covers the rubber packing part to prevent invasion of
liquids into the board.
Mount the GOT onto the control panel.
6
When the control panel is dirty, clean the control panel.
The panel cutting dimensions and mounting screw tightening
torque with the protective cover for oil are the same as those
without the cover.
8 - 14

8.8 Protective cover for oil

8.8.2 Installation procedure

Please do not pull the oil cover
more than the necessity,
and do not bend it extremely.
The seat part and the rubber part
in the display part might flake off.
Protective Cover For oil
The corner is hung.
The corner on the left is hung and the oil cover is hung
from A side to D side on the starting point sequentially.
A
D
C
Make sure that corners of protective
cover for oil match those of GOT front.
Protectivecover
for oil
GOT
B
Panel cut
dimensions
Mounting metal fixture
Control panel