Toshiba LF620 Instruction Manual page 64

For example, if the setting range is 10m/s and display digit setting is 1/100, the measured value will
be displayed to the first decimal place.
Setting range＝１０．００００ ｍ／ｓ
Likewise, when the setting range 1m/s and display digit setting is 1/100, the measured value will be
displayed to the second decimal place.
The numbers less than the displayed digits will be rounded.
Note: The maximum display digits for flow velocity, flow rate and custom value are 7 digits.
If the measured value exceeds 7 digits, the displayed value remains fixed at the maximum display
value.
● Changing the totalized flow volume direction
You can change the totalized flow volume direction as described below.
The following is an example to change the Display 1 setting from Fixed forward totalized flow (F)
to Bidirectional flow (B).
Switch operation
STEP1
STEP2
STEP3(=END)
Maximum effective digits
Display example
DSPL1
3
m F
ESC
DSPL1
3
m F
DSPL1
3
m B
DSPL1
3
m B
SET OK?
ESC O K
One hundredth of
maximum effective digits
Select "DSPL1" from the setting item
selection menu.
The currently set display setting (m
this example) appears.
Then push
The switches at the bottom change.
(
At the same time, the cursor appears.
Push
third unit (totalized flow direction) and then
push to change the direction.
Then push
temporarily.
Pushing
whether the setting is OK or not.
If OK, push
setting, push
Pushing
ESC
and exits the setting screen.
N O
− 63 −
6 F 8 A 0 9 2 7
Description
3
.
are shown.)
to move the cursor to the
to set the display unit
shows a message to confirm
. If you need to redo the
O K
.
N O
cancel the setting operation
F in