Privacy Masking Tab - Sony SNC-WR600 User Manual

Timer
Normally the camera works in day mode. It switches to
night mode at the time you set in Timer of Day/Night in
the Schedule menu.
Sensor input
Controls the day/night mode by synchronizing it with
the sensor input.
Select the synchronized sensor from Sensor input 1,
Sensor input 2, Sensor input 3 and Sensor input 4.
While a sensor input is detected, the camera works in
night mode.
Status
Displays the day/night function status.
Near-IR compensation
Adjust background light when using the IR lamp or
where there is much near short infrared ray. Select the
checkbox to increase the accuracy of auto-focus in night
mode.
OK/Cancel
See "Buttons common to every menu" on page 21.

Privacy masking Tab

Using the privacy masking enables you to hide images
by masking specified parts of the images when
streaming.
Note
Perform the following before setting the privacy
masking.
• Deselect the checkbox of Stabilizer in the Installation
tab of the System menu. After setting the privacy
masking, set the Stabilizer function again.
32
Setting the Camera Image and Audio — Video / Audio Menu
Preview screen
This screen is for monitoring images and configuring
privacy masking.
You can move the position of the privacy mask displayed
on the preview screen by drag and drop.
Effect
Set the effect of privacy masks.
Color
Specify the color of privacy masks. This setting is
common to every privacy mask.
Position
Select the number corresponding to the display position
on the preview screen.
After completing the configuration, register by clicking
OK.
Clear
Click the button to delete the privacy mask set in
Position.
Do not display mask in wide zoom range
You can switch to display/hide the privacy mask at the
specified zoom position.
When the checkbox is checked, the privacy mask will
not be shown if the zoom position is on the Wide side
rather than the specified zoom position.
Display mask from current position
When you click the Set button, display/hide of the
privacy mask will be switched.
The privacy mask will not be shown if the zoom position
is on the Wide side rather than the specified zoom
position.
Mask range
Click on the bar to set the zoom position at where
display/hide of the privacy is switched.
This can be also set by inputting a number and clicking
the Set by value button.
Clear all
Click the button to delete all privacy mask.
Call
Click the button to move the privacy mask set in
Position to the center of the image.