Table of Contents
Advertisement
SAFETY SUMMARY
NOTICE precautions (Continued)
Referring to the instruction manual about each module unit of the liquid chromatograph
system, set up the automatic liquid feed stop function (such as the pressure limiter function
of the pump unit) to prevent a possible trouble.
For detailed information, refer to the instruction manual about the ChromasterUltra R
6170 Binary Pump.
Disposal of Waste Solution
Be sure to collect waste solution and treat it for proper disposal in accordance with the relevant
laws and regulations regarding water pollution control and sewage treatment.
Improper treatment of waste solution may result in environmental pollution and could also lead
to a penalty.
Caution on High Pressure
High pressure is used in the liquid chromatograph system. Chemicals may spurt from the
instruments. When using a toxic solvent, wear proper protective eyewear (e.g., safety goggles).
Accuracy and Precision of Measured Values
Carry out periodic inspection and check whether the system is operating normally.
If necessary, conduct measurement on a control sample.
Before Turning on Xenon Lamp Again
After the xenon lamp is turned off, it remains very hot for a while. Under this condition, it is
not allowed to turn on the xenon lamp again for measurement.
Before turning on the xenon lamp again, wait for at least five minutes.
SAFETY - 25
S
Advertisement
Table of Contents
