Table of Contents
Advertisement
Installing DC Input Power Cables
4.4
1. You are advised to connect the battery terminals (BAT+ and BAT–) on the switch side to the
inverter and connect the other side to the cascaded battery.
2. For battery terminals, use the delivered Staubli MC4 positive and negative metal terminals and
DC connectors. Using incompatible positive and negative metal terminals and DC connectors
may burn the cables or damage the module. The resulting device damage will not be covered
under warranty.
Assembling DC Connectors
Positive metal
terminal
Negative metal
terminal
Installing DC Input Power Cables
Use dedicated insulated tools to connect cables. Ensure that battery cables are connected to
correct polarities. If the battery cables are reversely connected, the battery may be damaged.
PV-CZM-22100/19100
Ensure that the cable
cannot be pulled out
after being crimped.
Ensure that cable
polarities are
correct.
Use the wrench
shown in the figure
to tighten the
locking nut. When
the wrench slips
during the
tightening, the
locking nut has
been tightened.
14
Positive
connector
Negative
Click
connector
PV-MS-HZ
Open-end
wrench
Advertisement
Table of Contents
