Table of Contents
Advertisement
Chapter 5 Installation
Step 6. If applicable: Make sure that the battery connectors are connected together.
Step 7. Put back the battery packs, screw back the metal protection cover and the front panel, then clip the
center cover.
Step 8. Make sure that the EBM battery circuit breaker is turned on.
Rack mounting of UPS, EBM, and accessory modules
When installing the UPS unit's power module, pay attention to any connectors on the
Attention!
back side of the UPS unit such as RPO and ROO, serial connectors etc. Make sure that
these are not getting damaged!
When installing a UPS unit and any additional EBMs into a rack do not leave any gaps
between any module! This means that any modules must be mounted adjacent to each
other! See also the
installation. This also applies to the tower installation of the UPS units.
Leaving gaps between modules can damage the UPS and any interconnection cables! This
can lead to the UPS unit malfunctioning!
Note that the thick power cables running between the UPS power module and any EBM
carries a high electrical current of a couple of Ampères!
Any damage caused by incorrect physical installation and the subsequent repair work is
not covered by UPS warranty or maintenance contract.
Follow steps 1 to 7 in
6U Rack or Tower UPS RT8kVA and RT11kVA IUOMG
images
in
Chapter 5 Installation
Preparing the EBM for rack mounting
/
Rack Installation
for correct UPS
for module mounting on the rails.
53
Advertisement
Table of Contents
