Table of Contents
Advertisement
Original installation and operation manual
Home -> Configuration -> Meas. Point
The measuring point is stored for each leak in the corresponding leakage
data and can be viewed later on in the software's leak report.
-> LeakTag: Automatically incremented by one after every stored
measurement
You can change all the information for the measuring point by tapping the
corresponding text field or load stored measuring points from the internal
database.
After this, a menu with the existing / stored entries will appear.
If you want to select a stored value, select it (it will be highlighted in
green) and then tap "OK."
If you want to enter a new measuring point instead, tap the "new" button
to open the input menu.
Enter the text you want and confirm by tapping "OK."
Follow the same steps for the Company, Building and Place information.
To delete individual entries, tap the "delete" button.
METPOINT
CID
®
25 | 56
Advertisement
Table of Contents
