Table of Contents
Advertisement
Original installation and operation manual
10. Automatic distance measurement
The new intelligent horn features an integrated distance measuring module.
Prerequisites for firmware and hardware:
In order to be able to use this functionality, the following prerequisites must first be met:
•
The main board must be "intelligent" so that the main body of the METPOINT
communicate with each other.
•
The firmware version on the METPOINT
the "Downloads" section of the corresponding homepage.
If these prerequisites are met, the METPOINT
distance measuring is connected.
Description of functionality:
1.
2.
3.
Note: For the horn, the valid distance range is 1 ... 6 meters (40 ... 236 inches).
4.
®
CID must be V3.02 or higher. The latest firmware can be downloaded from
CID will automatically detect that an intelligent tool with automatic
®
The laser must be started in order to activate the distance measurement, just
like with all other tools.
The METPOINT
®
CID will then show the measured distance on the display. In
this case, the distance is 3.49 meters o 137 inches depending on the selected
unit system.
In order to automatically use the measured distance to calculate costs, you will
need to enable the "Distance by Laser" option under "Parameter."
Important: The laser must be switched on before you enable "Distance by
Laser." Otherwise, the icon will flash yellow and red and say "Laser?".
The METPOINT
CID will now update the distance automatically. The currently
®
measured distance will be shown in the grey "Dist:" bar. Meanwhile, the distance
used for cost calculations will be shown in the small bar at the bottom left next
to the pressure.
METPOINT
CID and the tool will be able to
®
CID
®
15 | 56
Advertisement
Table of Contents
