Encoder Profile - Bosch AUTODOME IP starlight 5000i IR User Manual

AUTODOME IP starlight 5000i IR
Longitude
Longitude is the east-west position of the camera in the spherical coordinate system WGS 84.
Ground level [m]
The elevation of the ground above sea level. To determine the elevation of the camera, add the
Ground level [m] value and the Height [m] value of the camera.
Azimuth [°]
The orientation of the camera in a counter-clockwise angle starting with 0° in the east (WGS
84) or on the X-axis (Cartesian). If the camera is directed towards the north (WGS 84) or the
Y-axis (Cartesian), the azimuth is 90°.
5.2

Encoder Profile

For the video signal encoding, you can select a code algorithm and you can change the presets
for the profiles.
You can adapt the video data transmission to the operating environment (for example network
structure, bandwidth, data load). To this end, the camera simultaneously generates two data
streams (Dual Streaming), which compression settings you can select individually, for example
one setting for transmissions to the Internet and one for LAN connections.
Pre-programmed profiles are available, each giving priority to different perspectives.
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
!
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
Note: In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections.
Notice!
i
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
If required, enter a new name for the profile.
Bit rate optimization
The bit rate optimization defines the optimization strength. These must be combined with the
appropriate scene mode. The Bit rate optimization and Maximum bit rate work in a quality-
driven mode. The encoder generates a bit rate up to the maximum setting if the scene
requires it.
For maximum image quality, apply minimum bit rate reduction (Maximum quality). This will
also greatly increase the file size. If maximum bit rate reduction is applied, the image will have
less quality, but the file size decreases significantly (Minimum bit rate).
Select the necessary bit rate optimization setting:
–
–
–
–
–
Bosch Security Systems
Off: bit rate optimization is disabled
Maximum quality
High quality
Medium
Low bit rate
User Manual
Camera | en 23
2023-01 | 1.3 |