Bosch AUTODOME IP starlight 5000i IR User Manual page 40

40 en | Alarm
Note: If there is not enough computing power, priority is given to live images and recordings.
This can lead to impairment of the VCA system. Observe the processor load and optimize the
encoder settings or the VCA settings if necessary, or turn off VCA completely.
Help for VCA settings
A separate Help file provides information about configuring for the VCA settings.
Note: Full VCA configuration and Help is only available on the web browser when MPEG
ActiveX software from Bosch is installed on your computer. MPEG ActiveX software is available
from the Bosch Security Systems DownloadStore (https://downloadstore.boschsecurity.com/)
To open the VCA Help in the web browser:
1.
2.
3.
4.
VCA configuration
Select one of the profiles here to activate it or edit it.
You can rename the profile.
1.
2.
Do not use any special characters, for example &, in the name. Special characters are not
supported by the system's internal management.
The default option is Profile #1.
If you select the option Silent VCA, then the system creates metadata to facilitate searches of
recordings but no alarm is triggered. You cannot change any parameters for this configuration.
If you want to turn off VCA, then select Off.
If necessary, click the button Default to return all settings to their default values. A dialog box
appears with the message, "Configuration of the video content analysis (VCA) will be reset
to factory defaults. The changes will be lost. Click 'OK' to continue." Click OK to
acknowledge the message, or click Cancel.
Scenario
Scenarios are applications with pre-defined settings that are adapted to specific use cases. All
relevant settings, from tasks to metadata, are set automatically by the system.
The following scenarios are available:
–
–
–
–
–
Notice!
A camera calibration is required for all scenarios.
i
Using the scenarios will reset the VCA configuration to the scenario defaults.
All values (Metadata Generation and Tasks) can be edited after activating the scenario
defaults.
Delete tasks that do not fit your use cases.
2023-01 | 1.3 |
Select Configuration > Alarm >> VCA
Click Configuration. The VCA window appears.
Ensure that the VCA window is on top and active. If not, click the window.
Press F1.
To rename the file, click the icon to the right of the list field and enter the new profile
name in the field.
Click the icon again. The new profile name is saved.
Intrusion (one field)
Intrusion (two fields)
People counting
Traffic incidents
Traffic wrong way
User Manual
AUTODOME IP starlight 5000i IR
Bosch Security Systems