Table of Contents
Advertisement
Image Installation Procedure
7. Edit the
protocol.ini
it contains the following strings:
[network.setup]
version=0x3100
netcard=ms$elnk3,1,MS$ELNK3
transport=ms$netbeui,MS$NETBEUI
lana0=ms$elnk3,1,ms$netbeui
[protman]
DriverName=PROTMAN$
PRIORITY=MS$NETBEUI
[MS$ELNK3]
DriverName=ELpc3$
(or name of your network card driver: elpc3.dos -> elpc$)
IOADDRESS=0x300
MAXTRANSMITS=6
pcmcia_enabler=yes
INTERRUPT=0xB
[MS$NETBEUI]
DriverName=netbeui$
SESSIONS=6
NCBS=12
BINDINGS=MS$ELNK3
LANABASE=0
1. Ensure that the MW-520 unit is turned off, that the PCMCIA network card is
installed in the unit, and that it is connected to a network. (Note: The
orientation of the PCMCIA slot on the MW-520 unit is upside down from the
orientation of previous versions of MW-520 units.)
2. Make sure that you have opened file sharing to the directory with the image
file on the networked host PC. Finally, ensure that the Ghost application is on
the host PC and that the PC is on the same network with the MW-520 unit.
3. Connect the USB floppy to the MW-520 unit and insert the bootable floppy
disk that was created according to the "Floppy Preparation Procedure" section
included above.
4. Power-on the MW-520 unit and enter
You should see a color interface. Use it to map the network location on the
networked host PC to the network drive on the MW-520 unit, for example:
drive "X" to \\OurFileServer\images.
1. Exit the
program and change directories to the network drive.
NET
2. Launch
GHOST.EXE
3. From within GHOST, choose
4. Choose the image file you need from the networked PC's shared directory.
Loading a New System Image
in the
directory of the floppy disk, so that
\mswgcn\
from the DOS command prompt.
NET
from the DOS command prompt.
Local -> Disk -> From Image
47
.
Advertisement
Table of Contents
