Installation Steps
3.1
Custom Application Drawing Package
Included with your analyzer is a custom application drawing package that provides drawings
and information pertinent only to your analyzer. You should have this package readily available
during installation.
Typical drawings may include:
● System Block and Utility Requirements
● System Outline and Dimensional Drawings
● Sampling System – Plumbing and Spare Parts List
● Sampling System Dimensional Diagram
● Sampling Probe
● Electronic Controller – Internal Layout
● Applicable Wiring Diagrams
● Oven Plumbing Diagram – Sensor Near Electronics
● Recommended Spare Parts - Analyzer
● Manufacturing Test Charts
● Stream Composition Data
3.2
Considerations for Pulsed Discharge Detector Installation
Special installation considerations may be required for installation, power, gas supply, wiring,
etc. in association with the Valco Pulsed Discharge Detector. If your Maxum II is equipped with
this type of detector, see the custom documentation provided with the Maxum II and the
Instruction Manual for the Pulsed Discharge Detector that is available from Valco Instruments
Co. Inc.
Installation Manual
Installation Manual, 12/2019, 2000595 Rev 1
3
13