Sony Airpeak S1 Startup Manual page 31

[2] Mounting the camera on the gimbal
1
Place the camera in the gimbal.
Loosen the locking screws on both sides of the gimbal frame, extend the tilt top bar to make it higher, and place the
camera in the gimbal from the front. Slide the camera plate attached to the camera into the groove on the bottom
part of the frame.
Locking
screw
2
Secure the camera in the gimbal.
Lower the tilt top bar, tighten the locking screws on both sides, and tighten the top camera screw on the hot shoe
adapter screw. Tighten the lever on the bottom of the frame to secure the camera.
Top camera
screw
Tilt top bar
Locking
screw
Lever
31