Panasonic FP7 Series User Manual page 121

Name
Link register
Unit memory
System data
register
Index register
Timer set
value area
32-
Timer elapsed
bit
value area
dev
ice
Counter set
value area
Counter
elapsed value
area
Signed
decimal
constants
Unsigned
decimal
constants
Hexadecimal
constants
Co
nst
Single-
ant
precision
floating-point
format real
number
Double-
precision
floating-point
format real
number
(Note 1) Figures in the table indicate the number of devices that can be used in the program. The actual inputs
and outputs that can be used vary by configuration.
(Note 2) Operation devices are categorized into "hold type", which memorizes the status immediately before a
power failure or switching to the PROG. mode, and "non-hold type", which resets the status. Non-hold
area is cleared to zero when the unit is powered on or the mode is switched between PROG and
RUN.
Types of operation devices
Internal relays (R), Data registers (DT), Link relays (L), Link
registers (LD)
WUME-FP7CPUH-09
Usable devices and ranges
16,384 words (LD0 to LD16383)
LD
(Note 2)
UM
Max. 512K words per unit
SD Approx. 110 words
15 double words (I0 to IE)
I
(with switching function)
4,096 double words
TS
(TS0 to TS4095)
4,096 double words
TE
(TE0 to TE4095)
4,096 double words
CS
(CS0 to CS4095)
4,096 double words
CE
(CE0 to CE4095)
K－32768 to K32767
K
K－2147483648 to K2147483647
U 0 to U65535
U
U 0 to U4294967295
H0 to HFFFF
H
H0 to HFFFFFFFF
SF-1.175494 × 10
SF
SF 1.175494 × 10
DF-2.2250738585072014 × 10
DF
DF 2.2250738585072014 × 10
This is a shared data memory which is used
within the PLC link. Data is handled in 16-bit
units (one word).
This device is for accessing the unit memory
(Note 3) of intelligent units. Its size varies by unit, and
is allocated by default.
Data memory for storing specific data.
Various settings and error codes are stored.
Register can be used as an address of
memory area and constants modifier.
Data memory for storing timer target data. It
corresponds to the timer number.
(Note 2)
Data memory for storing timer elapsed
value. It corresponds to the timer number.
(Note 2)
Data memory for storing counter set value. It
corresponds to the counter number.
(Note 2)
Data memory for storing the elapsed value
during operation of a counter. It corresponds
(Note 2)
to the timer number.
(for 16-bit operation)
(for 32-bit operation)
(for 16-bit operation)
(for 32-bit operation)
(for 16-bit operation)
(for 32-bit operation)
-38
to SF-3.402823 × 10
-38
to SF 3.402823 × 10
-308
to DF-1.7976931348623158 × 10
-308
to DF 1.7976931348623158 × 10
8.1 CPU Unit Specifications
Functions
38
38
Hold or Non-hold
Can be set as non-hold type or
hold type by the tool software.
308
308
8-9