Installing the Upper T-fitting and Inlet
Hose
1. Install the 2 large O-rings into the O-ring grooves at
either end of the hub connector
Figure 38
1. Retainer
2. Lower T-fitting (machine)
2. Route the inlet and upper T-fitting that you assembled
in
Assembling the Upper T-fitting, Inlet Hose and Ball
Valve Hose (page 19)
Figure 39
1. Inlet hose
2. Upper T-fitting
(Figure
38)
3. Hub connector
4. Large O-rings
as shown in
Figure
39.
3. Retainer
3. Install the upper T-fitting onto the hub connector
and secure the fitting and connector with the retainer
(Figure
39) that you removed in step
the Inlet Hose (page
4. Align the flanged elbow and a the gasket that you
removed Secure the flanged elbow the hose with the
hose clamp
(Figure
Removing the Inlet Hose (page
1. Flanged clamp
2. Gasket
5. Secure the inlet hose to the pressure filter head with the
gasket and flanged clamp
in
1
of
Removing the Inlet Hose (page
20
2
of
Removing
18).
40) that you removed in
18).
Figure 40
3. Flange (pressure filter
head)
4. Flange (90° fitting—inlet
hose)
(Figure
40) that you removed
18).
3
of