5. Install a 90° barbed fitting (3/4 inch NPT x 3/4 inch)
onto each of the threaded openings of the rinse-nozzle
bulkheads
(Figure
1
2
1. 90° barbed fitting (3/4 inch
NPT x 3/4 inch)
6. Align the 90° barbed fittings toward the middle of the
right side of the machine.
4
Installing the Rinse Pump
Parts needed for this procedure:
2
Carriage bolt (3/8 x 1 inch)
2
Flanged Locknuts (3/8 inch)
1
Rinse-pump mounting bracket
2
Straight-barbed fitting (1/2 inch NPT x 1/2 inch)
1
Nipple (1/2 inch NPT)
1
Pressure filter
1
Rinse pump
1
Valve mount
4
Bolt (1/4 x 1-3/4 inch)
4
Washer (1/4 inch)
4
Serrated-flange nut
2
Small hairpin
Installing the Valve Mount
1. Remove the bolt (3/8 x 5 inch), washers, flanged
locknut, and hairpin that secure the right, rear tank
straps at the top of the tank.
Note: Retain the bolt (3/8 x 5 inch), washers, flanged
locknut, and hairpin.
19).
G022283
Figure 19
2. Rinse-nozzle assembly
2. Install 1 carriage bolt (3/8 x 1 inch) in the
upper-inboard holes of the right, rear tank strap
20).
Note: Loosely thread a flanged locknuts (3/8 inch)
onto the carriage bolt.
1
2
1. Nut
2. Carriage bolt
3. Install 1 carriage bolts (3/8 x 1 inch) in the
lower-outboard holes of the right, rear tank strap
(Figure
20).
4. Install the tank strap hardware that you removed in
to secure the straps to the tank.
Note: Ensure that the square portion of the carriage
bolts are seated in the square opening in the tank straps.
Note: Make sure that the straps are flush to the tank.
Do not overtighten tank strap hardware.
5. Assemble the valve mount to the 2 carriage bolts (3/8
x 1 inch) using 2 flange locknuts
Assembling the Pressure Filter and
Rinse Pump
Note: Apply PTFE tape to the threads of the taper-threaded
fittings used in the sprayer and rinse systems.
1. Assemble nipple (1/2 inch NPT x 1/2 inch) into
the inlet of the pressure filter assembly and the
straight-barbed fitting (1/2 inch NPT x 1/2 inch) into
the outlet
(Figure
Note: The arrow at the top of the pressure filter
points to the outlet side of the filter head.
12
3
4
Figure 20
3. Valve mount
4. Hairpin
(Figure
20).
21).
(Figure
1
g024697
1