Toro Multi Pro 1750 Operator's Manual page 19

Assembling the Upper T-fitting, Inlet
Hose and Ball Valve Hose
Note: To insert the barbed fitting into the hose more easily,
apply a light coat of a non-petroleum-based lubricant, such as
vegetable oil to the barbed end of the fitting.
1. Insert the flanged elbow that you removed in step
Removing the Inlet Hose (page 18)
2.5 x 66 cm (1 x 26 inch) and secure the fitting with the
clamp that you retained
Figure 36
1. Flanged elbow (machine)
2. Hose clamp
3. Inlet hose 2.5 x 66 cm (1
x 26 inch)
4. 90° hub fitting
2. Insert the barbed end of a 90° hub fitting into the other
end of the inlet hose and secure it with a hose clamp as
shown in Figure 36.
Note: Align the face of the elbow with the face of
the 90° hub fitting.
3. Assemble an O-ring into the O-ring groove of the 90°
hub fitting (Figure
4. Insert the hub of the 90° fitting into one end of the
upper T-fitting (Figure
the T-fitting with a retainer.
5. Install the large O-ring into the O-ring groove of the
reducer hub and the small O-ring into the O-ring
groove of the 90° hub fitting
into the inlet hose
(Figure 36)
5. O-ring
6. Upper T-fitting (kit)
7. Retainer
36)
36) and secure the hub fitting
(Figure 37).
3 of
1. O-ring (large)
2. Reducer hub
3. Transfer hose 1.9 x 61 cm
(3/4 x 24 inch)
4. Hose clamp
6. Install the 90° hub fitting into the reducer hub and
secure the fittings with a retainer
7. Assemble transfer hose 1.9 x 61 cm (3/4 x 24 inch)
onto the barbed end of a 90° hub fitting into and secure
the hose and fitting with a hose clamp
19
Figure 37
5. 90° hub fitting
6. Retainer
7. O-ring (small)
(Figure 37).
(Figure 37).