Toshiba Aquilion TSX-101A/I Series Site Planning Manual page 27

(3) Making the frames for resin application
1. Cut off the plastic L-angle plates along the marking line using a saw. Treat the
corners as shown below.
2. Tape along the marking line of the plastic L-angle plates that have been cut off.
1) Tape the outside of the plastic L-angle plate to secure it.
2) Use the spatula to spread the caulking compound all over the corner inside the
L-angle plate.
3) Tape outside sections of the corners between the plastic L-angle plates.
4) Cut out part of the plastic L-angle plates for the gantry and the patient couch to
make an epoxy resin passageway.
(This job must be performed to ensure that the bottoms of the gantry and the
patient couch are flush.)
Caulking compound
27
Secure with adhesive tape
Adhesive tape
No. 2A201-519EN*A