Advertisement
Installation
4.3 Wiring preparation for driver
SINAMICS V50 wiring preparation
Dismantled/mounted keypad: Push out keypad like fig. below (1), then take off it
along the 'P' direction. Mount it along the opposite direction.
Wiring preparation: Loosen the clip 3/4, then open along the 'O' direction, take off
along the 'P' direction.
Take off along the opposite direction.
SINAMICS V50 Metal-sheet enclosure type A.
The АС-in and AC-out of some drivers are at two sides of driver.
Dismantling covert: dismantle the screw 1/2, open covert along 'O' direction, and
take off it along 'P' direction.
Dismantling cover2: dismantle the screw 3/4, open cover2 along 'O' direction, take
off it along 'P' direction.
SINAMICS V50 Metal-sheet enclosure type В.
Dismantling cover: dismantle the screw 3/4, open cover2 along 'O' direction, take off
it along 'P' direction. The wiring holes at two sides of driver, break it to create holes
for wiring
SINAMICS V50 converter
10
Operating Instructions, 04/2022, FW V1.0, A5E44777205B AB
Advertisement
