Set The Character Spacing Of A Character Object Along An Arc - Panasonic LP-GS Series Operation Manual

9 Character object
(1) Character spacing
4. Specify a value for "Character spacing [mm]" or "Character string width [mm]".
The available setting names change depending on your selection for "Character spacing
type".
•
•
5. If you select "Proportional 1", specify the width of a blank character under "Space width
[mm]".
Related topics
Specify parameters under "Compatibility with former models"

Set the character spacing of a character object along an arc

9.11 Set the character spacing of a character object along an arc
There are two different options to specify the character spacing for arc aligned character
objects. You can specify whether the character spacing is defined by angle or by length.
• If "Arc outside, char. spacing by angle" or "Arc inside, char. spacing by angle" is set for
"Character arrangement", select a character spacing type and set an angle value.
• If "Arc outside, char. spacing by length" or "Arc inside, char. spacing by length" is set for
"Character arrangement", select a character spacing type and set a length value.
For details, refer to the following topics:
• Set the character spacing by specifying an angle
• Set the character spacing by specifying a length
102
(1)
(1)
For "Fixed spacing" and proportional settings ("Proportional 1", "Proportional 2",
"Proportional 3"), input the desired value under "Character spacing [mm]".
For "Justify", input the desired value under "Character string width [mm]".
(page 228)
(page 102)
(page 103)
(page 104)
ME-NAVIS2-OP-1