Installing The Motherboard; Installing Expansion Cards; Installing The Air Shroud - Bosch DIVAR IP 6000 Series Installation Manual

DIVAR IP 6000 (3U)
To replace the front port panel:
1.
2.
3.
4.
5.
6.
10.9

Installing the motherboard

Motherboard problems will be handled by trained support people only.
10.10

Installing expansion cards

The chassis includes seven PCI slots for full-height, full-length expansion cards, for example
the graphic card or sound card.
To install expansion cards:
1.
2.
3.
4.
10.11

Installing the air shroud

The air shroud does not require screws for its installation.
Bosch Sicherheitssysteme GmbH
1
1 DVD-ROM
Turn off and unplug the unit.
Remove the chassis cover.
Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
Insert the new front port panel unit in the slot until the tab locks into place.
Connect the data and power cables to the backplane and motherboard.
Turn off the system, lay the chassis on a flat surface, then open the chassis cover.
Remove the screw holding the chassis slot shield in place.
Insert the expansion card into the card slot, while aligning the expansion card shield with
the slot in the rear of the chassis.
Secure the expansion card shield to the chassis using the screw previously removed.
2
Installation Manual
Maintenance | en
2
Front port panel
41
2016.08 | V2.1 | DOC