Table of Contents
Advertisement
DIVAR IP 6000 (3U)
6
RAID setup
If you have added third party hard drives to empty units, you must configure the hard drives
using the RAID setup utility. The RAID setup utility is pre-installed on the system.
Notice!
The RAID setup process is not necessary for units with pre-installed hard drives. These units
are delivered with a default configuration.
DIVAR IP systems are configured in RAID 5 mode by default. Alternatively, RAID 5+ or RAID 6
can be used. In this case all settings remain unchanged except for the RAID level.
6.1
RAID setup using Remote Desktop Connection
To configure the hard drive using Remote Desktop Connection:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Change the following settings:
11. Click Create Virtual Drive.
12. Finish the wizard and exit the MegaRAID Storage Manager program.
13. On the DIVAR IP desktop, double-click the Server Manager
14. Click File and Storage Services > Disks.
15. Right-click the disk named LSI..., then click New Volume.
16. Run through the wizard without changing the default settings.
17. Change the Volume label to Data.
18. Finish the wizard and exit the Server Manager program.
Notice!
Before you can store video recordings on the drive, you must perform a basic setup using the
video software configuration tool, for example, Configuration Manager or Bosch VMS
Configuration Client.
Bosch Sicherheitssysteme GmbH
Install all hard drives.
Turn on the system.
Open the Remote Desktop Connection and log on to DIVAR IP as follows.
–
In the Computer box, enter the IP Address of the DIVAR IP system you want to
connect to.
–
In the User name box, enter BVRAdmin.
On the DIVAR IP desktop, double-click the MegaRAID Storage Manager icon.
Enter user name and password, and then click Login.
–
User name: BVRAdmin
–
Password: customer-dependent (default: WSS4Bosch)
Click Create Virtual Drive, then click Advanced mode.
Select RAID 5 as RAID level (default configuration) and follow the steps in the Virtual
Drive wizard.
Select and add all hard drives that are part of the RAID group (default: all).
Click Create Drive Group.
–
Initialization state: Fast Initialization
–
Strip size: 64 KB
–
Write policy: Always Write Back
Note: All other settings remain unchanged.
Installation Manual
RAID setup | en
27
icon.
2016.08 | V2.1 | DOC
Advertisement
Table of Contents
