Removing The Chassis Cover; Installing A Sata Hard Drive; Removing A Hard Drive From The Chassis - Bosch DIVAR IP 6000 Series Installation Manual

DIVAR IP 6000 (3U)
10.3

Removing the chassis cover

To remove the chassis cover:
1.
2.
3.
4.
Notice!
Except for short periods of time, do NOT operate the server without the cover in place. The
chassis cover must be in place to allow proper airflow and prevent overheating.
10.4

Installing a SATA hard drive

This chapter describes the removing and installing of SATA hard drives.
10.4.1

Removing a hard drive from the chassis

The hard drives are mounted in hard drive carriers to simplify their installation and removal
from the chassis. These hard drive carriers also help promote proper airflow for the hard drive
bays.
Bosch Sicherheitssysteme GmbH
1
2
2
1 Fixing screws
2 Release tabs
Disconnect the power supply, lay the chassis on a flat surface.
Remove the two screws on each side of the cover, which secure the cover to the chassis.
Press the release tabs to remove the cover from the locked position. Press both tabs at
the same time.
Once the top cover is released from the locked position, slide the cover toward the rear
of the chassis and lift the cover off the chassis.
3
3
Installation Manual
Maintenance | en
1
Chassis cover
35
2016.08 | V2.1 | DOC