Turning On The System - Bosch DIVAR IP 6000 Series Installation Manual

24 en | Rack installation
bezel is included on the chassis, remove it. Then attach the two front brackets to each side of
the chassis, then the two rear brackets positioned with just enough space to accommodate
the width of the Telco rack. Finish by sliding the chassis into the rack and tightening the
brackets to the rack.
4.4

Turning on the system

To turn on the system:
1.
2.
2016.08 | V2.1 | DOC
Plug the power cord from the power supply unit into a high-quality power strip that offers
protection from electrical noise and power surges. We recommended using an
uninterruptible power supply (UPS).
Press the power button on the control panel to turn on the system.
Installation Manual
DIVAR IP 6000 (3U)
Bosch Sicherheitssysteme GmbH