Microphone, Speaker, Or Dialer Not Paired With Base Station; Telephone Interface Problems; Cannot Dial Numbers; Two Phones Using The Same Extension - Yamaha Revolabs FLX2 System Manual

the Base Station. All components should automatically connect to the Base
Station after a few seconds.
2. The Base Station is powered up, but the Status LED indicates a fault has
happened by missing every fifth green double flash. Power down and power up
the Base Station. All components should reconnect to the Base Station after a
few seconds. The fault message in the Base Station will continue (every fifth
double flash is skipped) – this just shows that a fault has happened in the past
and can be ignored. If the components still do not connect to the base please
contact Revolabs Support.
3. Are the Dialer, Microphone, and Speaker out of reach of the Base Station?
Please bring the components closer to the Base Station to see whether this
resolves the issue.
4. Power down the Base Station, the Microphones, the Dialer, and the Speaker.
Now power up the Base Station. Once the Base Station is powered up (double
green flashes of the Status LED), power up the Dialer, and then the Microphones
and the Speaker. The components should now connect to the Base Station.
5. If the components still do not connect to the Base Station, please re-pair the
components that have not connected to the Base Station, beginning with the
Dialer. How to pair the components is explained on page42.
6. If the components still do not connect to the Base Station, please contact
Revolabs support.

Microphone, Speaker, or Dialer not paired with Base Station

Please follow the descriptions on page 42 on how to pair the different components with
the Base Station.

Telephone Interface problems

"Line in Use" even though there is no call
If you see messages that the telephone line is in use, even though no call is currently in
progress, please change the Disconnect setting from OFF to ON (see the section on
Phone Settings on page 48). This should resolve this issue.

Cannot dial numbers

When using FLX on a DSL analog telephone line, the DSL filter needs to be installed. If
this is not the case, calls might not go through.

Two phones using the same extension

If a second phone is connected to the same extension a FLX Conference phone is
connected to, only one phone can be used at a time. If both phones are off-hook (in
use), audio will be distorted. Only one telephone should be used at a time.
56