Before using for the first time
Connecting via WPS
Your Wi-Fi router must support WPS
(Wi-Fi Protected Setup).
With the deflector plate retracted,
touch the On/Off sensor .
All symbols light up with reduced
brightness.
Press and hold the run-on option
control until the grease filter
and charcoal filter symbols light
up.
Touch the 2 control.
The deflector plate extends.
2 will light up constantly, 3 will flash on
and off.
The Wi-Fi connection must be started
on the rangehood at the same time as
on the Wi-Fi router.
Press the B control on the rangehood
after a few seconds.
After a short while 2 will light up
constantly, and 3 and B will flash on
and off.
The rangehood is ready for connection
during the next two minutes.
20
Start the WPS connection on your
Wi-Fi router.
When successfully connected 2 and 3
will light up constantly.
Quit connection mode on the
rangehood by touching the run-on
control .
The rangehood can now be operated
via the App.
If the connection fails, you have
probably not connected WPS on your
router quickly enough. Repeat the steps
above.
Useful tip: If your Wi-Fi router does not
support WPS, please connect via the
Miele App.