Table of Contents
Advertisement
Selecting extraction mode or
recirculation mode
The rangehood can be operated with
either extraction mode or recirculation
mode. The power of the fan is
adapted to suit the selected mode of
operation. The rangehood is set up at
the factory for recirculation mode. It
has to be reset for extraction mode.
To reset it for extraction mode, the
operating hours counter for the
charcoal filter(s) has to be deactivated.
With the deflector plate retracted,
touch the On/Off sensor .
All symbols light up with reduced
brightness.
Press and hold the run-on option
control until the grease filter
and charcoal filter symbols light
up.
Touch the charcoal filter symbol .
The charcoal filter symbol and one of
the fan power levels will flash.
Touch the B control.
Confirm your choice by touching the
charcoal filter sensor .
All the indicator lights will go out.
Extraction mode has now been set.
If you do not confirm your selection
within 4 minutes, the rangehood will
automatically revert to the previous
setting.
Before using for the first time
Activating/Deactivating
Plug&Play
Touch the On/Off sensor .
All symbols light up with reduced
brightness.
Press and hold the run-on option
control .
After a few seconds, the grease filter
and charcoal filter symbols light up,
and after a further 5 seconds the 1 fan
power level indicator lights up.
The deflector plate extends.
Then touch in turn
- the 1 control,
- the lighting control and
- the lighting control .
When Plug&Play is deactivated, the
indicators 1 and 3 will flash.
When Plug&Play is activated, the
indicators 1 and 3 will light up
constantly.
To activate, touch B.
The 1 and 3 indicators light up
constantly.
Touch 1 to deactivate.
The 1 and 3 indicators will flash.
Confirm the setting by pressing the
run-on control .
All the indicator lights will go out.
If you do not confirm your selection of
setting within 4 minutes, the rangehood
will revert to the previous setting.
17
Advertisement
Table of Contents
