Canon CXDI-31 Service Manual page 179

(7) Flat cable (FPC-A-AD) spreads well. Put the CST AD-IF board in place so that the
tension will be applied uniformly to the flat cables (FPC-A-AD). Fully tighten all the
screws, which were temporary tightened in the step (5) above.
(8) At reassembly, reverse the steps (1) and (2) above.
Note:
The exterior cover is made of a magnesium alloy. Remember that tightening the screws
with excessive force could strip the nut.
Note:
When attaching the rear cover, be careful not to pinch the power cables and the others
with the covers. Refer to "3.1.3 Notes on installing the rear cover in "3.1 Notes".
3. CXDI-31 Imaging Unit
- 23 -