Miele ProLine CS 1018 G Operating And Installation Instructions page 48

Installation
Fitting the ProLine element
 Feed the mains connection cable
down through the worktop cut-out.
 Starting at the front, position the
ProLine element in the worktop cut-
out.
 Using both hands, press down evenly
on the sides of the ProLine element
until it clicks into position. When
doing this make sure that the seal of
the appliance sits flush with the
worktop on all sides. This is
important to ensure an effective seal
all round the worktop.
Do not use any additional sealant
(e.g. silicone) on the ProLine
element.
If the seal does not sit flush with the
worktop in the corners, the corner
radius (≤ R4) can be carefully cut to fit
using a jigsaw.
48
Installing several ProLine elements
 Push the built-in ProLine element to
the side until the holes in the spacer
bar can be seen.
b
 Push the cover strip  into the
designated holes in the spacer
bar .
 Starting at the front, position the next
ProLine element in the worktop cut-
out.
 Proceed as described previously.
a