Configuring And Activating Interfaces; Monitoring Network Interface Cards - Nokia IP1220 Installation Manual

4
Installing and Replacing Network Interface Cards and Accelerated Data Path (ADP) Services Modules
The power indicator LED on the PMC carrier or ADP module illuminates green.
.
If you are replacing a NIC or ADP module with a one of the same type, the Nokia IPSO
operating system automatically recognizes the device and applies the original configuration.
If you are installing a new or different NIC or ADP module, configure the new device by
using Nokia Network Voyager. For information about how to access Network Voyager, see
"Using Nokia Network Voyager"

Configuring and Activating Interfaces

The Nokia IP1200 Series appliance automatically detects any new NICs or an ADP module
when the device is completely installed. Use Nokia Network Voyager to configure and activate
the logical and physical interfaces on the NIC or ADP module.
For information about how to access Network Voyager and the related reference materials, see
"Using Nokia Network Voyager"

Monitoring Network Interface Cards

You can assess the general operating condition of the NICs or the ADP module in your appliance
by looking at the LED status indicators on each device. The status indicators for each NIC are
explained in
indicators for each ADP module are explained in
Services Modules."
Use Network Voyager to access detailed port information. For information about how to access
Network Voyager, see
You can also use the Nokia IPSO tcpdump command to examine the traffic on a specific port.
56
All manuals and user guides at all-guides.com
on page 44.
Chapter 5, "About IP1200 Series Appliance Network Interface Cards."
"Using Nokia Network Voyager"
IP1220 and IP1260 Security Platforms Installation Guide
on page 44.
Chapter 6, "About IP1200 Appliance ADP
on page 44.
00315.2
The status