Table of Contents
Advertisement
The connectors are located near the back of the motherboard near the DIMM sockets.
Caution
Do not use the PMC connectors located at the front of the motherboard for the
encryption acceleration card. Those connectors are meant for the management NIC.
5. Position the three male PMC connectors on the card over the three female PMC connectors
on the motherboard.
The two sets of connectors should be aligned with each other. The four screw holes and four
standoffs should also be aligned with each other.
6. Push down on the card until it is properly seated on the motherboard.
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
A
Standoffs
Installing a Nokia Encryption Accelerator Card
B
Insert the card into
connectors
Screw card into standoffs
00324.1
105
Advertisement
Table of Contents
