Figure 65
1. Front of the machine
2. Jack brackets (front-axle
tube)
•
Front—the jack brackets of the front-axle tube
(Figure
65).
•
Rear—the rear-axle tube.
g375763
3. Rear-axle tube
4. Back of the machine
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (and immediately
after every washing).
Grease Specification: No. 2 lithium grease
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Open the hood; refer to
40).
3.
The lubricate the machine at the fittings at the
locations as follows:
•
Pump-driveshaft U-joint (3)
Note:
The pump-driveshaft is located Under
the hood.
•
Cutting-unit lift-arm cylinders (2 each)
(Figure
67)
42
40).
Opening the Hood (page
(Figure
66)
Figure 66
Figure 67
g003962
g012150