Installing Rear Weights - Toro Reelmaster 5610 Operator's Manual

4

Installing Rear Weights

Parts needed for this procedure:
Varies Rear weights (size varies with configuration)
Procedure
This machine complies with EN ISO 5395 and ANSI B71.4-2017 when equipped with rear weights and/or
41 kg (90 lb) of calcium chloride ballast is added to rear wheels. Use the following charts to determine the
combinations of weights required for your configuration. Order parts from your local authorized Toro distributor.
Groomers, roller
brushes, and/or
baskets
No
Yes
Important:
Always install tubes inside the rear tires before calcium chloride is installed. If a puncture
occurs in a tire with calcium chloride, remove the machine from the turf area as quickly as possible. To
prevent possible damage to the turf, immediately soak the affected area with water.
Use the following procedure to mount the appropriate amount of weight (see weight charts) to the top or
bottom of the rear bumper as shown in
1. Traction manifold
2. Spacers
3. Bolts
4. Washers
Weight P/N 110-8985-03
Number of weights Number of weights to
to meet ANSI (US) meet CE (European)
standards
0
4
Figure 33.
Fasteners (2 each
required) for weights
standards
0
3231-7 Carriage Bolt,
4
104-8301 Nut
Figure 33
5. Weight(s)
6. Carriage bolt
7. Nut
20
Weight Location
N/A N/A
1 on top of bumper and
3 under bumper
g005526