Hitachi CP-X2520 Service Manual page 37

Wiring around lamp house
(1) Wire and secure CNLAP
(2) Attach TSW and wire TSW cable
TSW
cable
Lamp House
Ribs
Wire the CNLAP in the procedure below.
1. Secure the connector housing of the CNLAP with
a screw.
2. Push the CNLAP into the space under the ribs on
the side of the lamp house.
3. Pass the CNLAP into the groove.
The boss is
between two
CNLAP
wires.
Two wires.can be
seen here separately.
Wiring diagram 6
OK
The wire
passes over the
boss.
Two wires.cannot be
seen here.
Face the printed surface
or the TSW to the outside.
NG