Wiring around PANEL DUCT
(1) Wire CNAIR, CNRC and AC-INLET cable
(2) Attach Wire #3000
Connect the CNAIR after attaching the PANEL
DUCT to the BOTTOM CASE in order to
prevent the components on the PWB
assembly SENSOR fro being damaged..
CNARI
PANEL DUCT
Projection
Pass the CNGD1 between the PANEL
DUCT and the boss in order to keep
away from the POWER FAN.
Boss
CNGD1
AC-INLET
cable
Wiring diagram 5
Put the excessive length of the
AC-INLET cable near the power
supply block.
Pay attention not to let
the cables protrude from
this rib to the lens side.
Pass the #3000
through his hook.
Fasten the #3000 and the
CNRC into the slit.
CNRC