Hitachi CP-X2520 Service Manual page 35

Wiring after attaching power supply block
(1) Attach CNTS and CNGD1
(2) Attach FE1 to CNPFC
Style the AC-INLET cable in order not
to make it loosened here, and put its
excessive length near the power
supply block. Pay attention not to
stress the soldering parts of the inlet.
Pass the CNGD1 through
the hooks of the ribs.
Put the ferrite
core FE2 here.
Put the ferrite core of the AC-INLET cable here.
Pass the AC-INLET
cable into this hook.
Raise the hook and put
the wires in it.
Pass
through this hook.
AC-INLET
cable
Wiring diagram 4
NG
A wire on the LAMP FAN
side is not in place.
Push the AC-INLET cable
into the end of the bosses in
order not to be released.
the #3020
Pass under this part.
Pass through the slit.
#3020