Table of Contents
Advertisement
4-5-3.
Rear Fan Assembly
Preparation
1.
Refer to
"4-2. Flow
Chart".
Procedure
1.
Remove the wire holder.
2.
Open the two wire clamps and remove the harness.
3.
Disconnect the harness from the connector (CN1) on the CN-3372 board.
4.
Remove the two screws to detach the rear fan assembly.
Harness
Wire clamps
CN1
(CN-3372 board)
Note
• When installing the rear fan assembly, do not put the harness between any parts.
• Avoid impact on the rear fan assembly.
5.
Install the removed parts by reversing the steps of removal.
PWS-4400
Wire holder
Harness
Rear fan assembly
PSW3 x 6
4-14
Advertisement
Table of Contents
