1-9.
To Initialize the IP Address
1.
Turn on the main power switch (primary power supply) on the rear of the unit to put the unit in standby mode.
2.
Insert a screwdriver (diameter 1 mm or less) or the like into the hole at the lower left of the front panel, and turn
on the ON/Standby button (secondary power supply) while pressing the reset switch at the back of the hole.
Note
• Insert a screwdriver or the like perpendicularly to the front panel.
• Strongly pushing a screwdriver or the like may damage the tactile switch at the back of the hole.
The distance from the hole entrance to the tactile switch is approx. 8.3 mm. Pay attention to this distance when
inserting a screwdriver or the like into the hole.
The SYSTEM indicator on the front of the unit blinks in purple and the IP address is initialized.
PWS-4400
1-32