Fc Group: Communication Parameter - Craftsman G10-0R7G-2SB Manual

6.13 FC Group: Communication parameter

Code
FC.00
When the master is writing the frame,the communication address of the slave is set
to 0,the address is the communication address.All slaves on the MODBUS fieldbus can
receive the frame.but the salve doesn't answer.Note:The address of the slave cannot set
to 0.
The communication of the drive is unique in the communication net.This is the
fundamental for the point to point communication between the upper monitor and the
drive.
Code
FC.01
0ÿ 1200bps
1ÿ 2400bps
2ÿ 4800bps
3ÿ 9600bps
4ÿ 19200bps
5ÿ 38400bps
6ÿ 57600bps
7ÿ 115200bps
This parameter can set the data transmission rate during serial
communication.Note,The baud rate between the upper monitor and the inverter must be
the same.Otherwise,the communication is not applied.The bigger the baud rate,the
quicker the communication speed.
Code
Name
Local address
Name
Baud rate selection
Name
125
Setting Range
0ÿ^2470 10
Setting Range
0ÿ^70 30
Setting Range