LG STB-3000 Setup Manual page 48

Cloning Procedures (Cont.)
(Continued from previous page)
9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then
press OK on the Installer Remote.
TEACH TO STB (TLX)
STB MANAGER
Select USB Memory Device
ˇ
USB Device 1: Device Name
Select the file to download, and then select UPDATE below.
STB-3000-UA00001.TLX
UPDATE
Teaching progress will be shown in a pop-up banner at the bottom of the Teach To STB (TLX)
screen. This process may take a few minutes. Do NOT remove the USB device while Teaching
is in progress. When the Teaching process is complete, an "Updating completed" message will
briefly be displayed, and then, the STB will reboot. *
10. Remove the USB memory device from the Target STB, and verify that the appropriate
configuration is now resident on the Target STB.
Note: If the Target STB was previously in Pass-through Mode, and the TLX file used for Teaching
contained an FTG Channel Map, the Target STB CPU is now in FTG Mode. Upon restart (and, if
applicable, confirmation of new video output resolution—see note below), the STB tunes according
to the Start Channel setting in the Installer Menu. If a Start Channel is specified, the STB will tune
to that channel, though, in the case of FTG Mode configuration, a channel banner will only be
displayed if the Start Channel is included in the FTG Channel Map (depending on your selection
in step 8, the channel banner will display either the Start Channel's logical channel number or
physical RF channel number). Otherwise, the STB will either return to the last channel tuned (STB
in Pass-through Mode) or tune to the first channel in the FTG Channel Map (STB in FTG Mode). If
the latter, remember that the channels in the FTG Channel Map are always arranged in logical order,
regardless of your selection in step 8.
Note: If you updated the STB configuration with a TLX file that included a change to Installer Menu
item 105 VID OUT FORMAT, when the reboot is complete, you will be prompted to confirm the new
video output resolution. See item 105 description on page 38 for further information.
*
STB-3000s with CPU software earlier than v3.00.70 will only reboot upon completion of a TLX update if the TLX
file included a change to Installer Menu item 105 VID OUT FORMAT (see also note regarding item 105 above).
48
BACK
Channel Tuning / Channel Banner Display
Logical
Physical
CANCEL
206-4272