LG STB-3000 Setup Manual page 19

Note: Zoning features are only applicable for STBs that will be configured using a TLX file (local or
remote configuration).
ZONES, LABEL, AND ROOM NUMBER
Wi-Fi Zone
< >
0
TV Zone
< >
0
Label
< >
-----
Room Number
Room Number
EXIT
1. Complete the appropriate field(s) as described below. Use the Left/Right arrow keys on the
Installer Remote to navigate between each of the fields.
• Wi-Fi Zone: Enables you to set a Wi-Fi Zone # so that the STB can be configured with a
particular access point's login data for wireless networking. Login data (i.e., SSID, security type,
and security key) may be provided in a TLX file to be used for configuration.
To assign a Wi-Fi Zone, navigate to the Wi-Fi Zone field at the top left of the screen, and use
the Left/Right arrow keys to specify the desired Wi-Fi Zone # (1–99).
• TV Zone: Enables you to set a TV Zone # so that the STB can be configured with Installer
Menu and/or TV Setup Menu settings intended only for the assigned Zone. The Installer Menu
and/or TV Setup Menu settings may be provided in a TLX file to be used for configuration. If
the STB is being configured for FTG Mode, the TV Zone # setting also allows the STB to omit
channels that have been restricted in the FTG Channel Map.
To change the TV Zone from its default value (0), navigate to the TV Zone field, and use the
Left/Right arrow keys to specify the desired TV Zone # (1–8).
• Label: Allows you to select a North, South, East, or West text label for this STB. In the Label
field, use the Left/Right arrow keys to select the applicable label.
• Room Number: Allows you to specify the number of the room—up to 16 characters—in which
the TV is located. To enter a room number, navigate to the Room Number field and press OK.
You can then use the number keys on the Installer Remote to direct enter a room number,
or you can use the arrow keys to select the appropriate alphanumeric character(s) from the
pop-up virtual keyboard at the bottom of the screen. When you are done, select Enter from the
virtual keyboard, and then press OK on the Installer Remote.
2. When you are ready to continue, select the appropriate option, as follows:
• To proceed to the next EZ-Manager screen, use the arrow keys to select NEXT, and then
press OK on the Installer Remote. Continue to the "Configure Pro:Centric Settings" section
on the following page.
• To use a USB memory device in conjunction with the STB Manager / USB Download Menu to
complete the configuration, continue to "USB Configuration" on pages 24 to 25.
206-4272
. If creating Wi-Fi Zones for AP settings, select the appropriate Wi-Fi Zone
# (1-99) based on the Wi-Fi Zone in which this STB is installed.
. If creating Zones for Installer Menu settings and/or Channel Mapping,
select the appropriate TV Zone # (0-8) based on the Zone in which this STB
is installed.
(See Commercial Mode Setup Guide for more information.)
. Select a Label and/or use the alphanumeric keypad on the remote to input
the Room Number.
. When done, select NEXT to continue.
ZONES & ROOM NUMBER
USB CONFIGURATION
01
NEXT
EZ-Manager Wizard (Cont.) EZ-Manager Wizard (Cont.)
19