Table of Contents
Advertisement
Video Options
To access a preset's video options, press the right arrow ( > ) button until the pointer is in
front of Video and press ENTER. Use the arrow buttons to view or change video options.
Table 2 describes each option.
•
Table 2
Option
In
Res
Rate
GOP
Temporal
BWFilter
Film
Aspect
Fmt
StatMux
Document Number: 504834-001
P r e s e t N a m e
< >
1
I n : N T S C
Video Options
Definition
Description
Input
Use this option to select an input and format type:
NTSC
PAL
PAL-M
525SD
625SD
OFF
Resolution
Use this option to select a horizontal resolution: 720, 704, 544,
528, 480, or 352.
For NTSC, PAL-M, and 525SD
SE-2000 encoders also supports a vertical resolution of 512.
For PAL and 625SD
olutions give improved picture detail, but require higher bitrates
to maintain details without noticeable compression artifacts.
Bit Rate
Select the desired video packet bit-rate (video transport stream
rate) as shown below:
SE-1010
SE-2000
Group of
Use this option to select a GOP rate: 1, 3, 6, 9, 12, 15, 18, 21,
Pictures
24, 27, or 30. The default is 15. GOP is the number of frames
(refresh
that occur before an
rate).
selection of 15 results in this sequence:
Temporal
SE-2000 Only Select the desired Pure Pixel motion adaptive
Filter
temporal filter: OFF, AUT (automatic), or a value from 1 to 10.
1 is the weakest filtering and 10 is the strongest filtering.
Brick Wall
SE-2000 Only Select the desired Pure Pixel adaptive spatial
Filter
filter: OFF, AUT (automatic), or a value from 1 to 10. 1 applies
the weakest filtering and 10 applies the strongest filtering.
Film Mode
Use this option to enable (ON) or disable (OFF) the film-mode
detection for 3:2 pulldown.
Aspect
Select the desired screen resolution signaling: 4:3 (standard
Ratio
aspect ratio) or 16:9 (widescreen aspect ratio).
Format
SE-1010 Only The LED displays 4:2:0 (for standard distribution
feeds). This value is read-only and cannot be changed.
SE-2000 Only Select the desired MPEG profile video: 4:2:0
(for standard distribution feeds) or 4:2:2 (for high-quality
contribution feeds).
Statistical
During normal standalone operation, this read-only field is set to
Multiplexing
OFF.
> V i d e o
A u d i o 1
R e s : 5 2 8 x 4 8 0
:
Selects NTSC analog composite input
:
Selects PAL analog composite input
:
Selects PAL 525 analog composite input
I
:
Selects Serial Digital Component Video, 525 line
I
:
Selects Serial Digital Component Video, 625 line
:
Video is not enabled
I
, the vertical resolution is 576. Higher res-
:
1.00 Mbps to 15.00 Mbps (in 10 kbps increments)
:
0.50 Mbps to 15.00 Mbps (in 10 kbps increments)
I
frame is repeated. For example, a
I
B
B
P
B
B
P
1
2
3
4
5
6
7
A u d i o 2
R a t e : 4 . 0 0
I
, the vertical resolution is 480.
B
B
P
B
B
P
B
8
9
10
11
12
13
14
B
I
15
1
13
Advertisement
Table of Contents
